Where a device has multiple PGC/PGD pin pairs you can use any of the pairs.  When programming all of the pins become ready to accept a new programming sequence, its only when debugging you need to have set the correct pair in the config bits, which you can do when first programming by setting the correct port in MPLABX.

We benefit hugely from resources on the web so we decided we should try and give back some of our knowledge and resources to the community by opening up many of our company’s internal notes and libraries through mini sites like this. We hope you find the site helpful.
Please feel free to comment if you can add help to this page or point out issues and solutions you have found, but please note that we do not provide support on this site. If you need help with a problem please use one of the many online forums.


Your email address will not be published.